Model GC60 Gamma Beam Irradiator
print this page Hopewell Designs, Inc.

The GC60 Gamma Beam Irradiator features a computer-controlled, shielded source carousel
and a precision three-axis linear positioning system.
It may be equipped with up to eight Cesium-137 and Cobalt-60 sources.

Standard Features: Model GC60 Control Console
Model GC60 Control Console
  • Automated irradiator control software
  • 8 position source carousel (typically seven active sources and one dummy)
  • Steel-encased lead and tungsten shielding
  • ISO 4037-1979 compliant beam collimator
  • Computer control of exposure time, attenuation, source selection, and linear positioning system
  • 3 axis precision linear positioning system
  • Fully programmable instrument calibration procedures
  • Video monitor(s) to view instrument under calibration (and irradiator system)
  • Laser alignment system
  • Fully shielded enclosure
  • Redundant and fail-safe safety interlock systems

General Specifications
Irradiator
Radiation Sources Cesium-137 sources up to 2200 Ci and Cobalt-60 sources up to 5 Ci
Beam Centerline Height 39" (1 meter) above floor
Beam Uniformity 30 cm x 30 cm at 1 meter
Shielding Type Steel encased lead and tungsten cast cylinder
Radiation Exposure Less than 0.25 mR/h measured 2 inched from enclosure surface
Linear Positioning System
Travel X = 600 cm, Z = 30 cm, R = 360º
Precision ±1 mm
Motion Control Servo motor and precision controller
Instrument Platform 16" (40.6 cm) diameter, engraved 1 cm gridlines, tapped holes every 10 cm


Model GC60 Gamma Beam Irradiator Diagram

Model GC60 Gamma Beam Irradiator Diagram

Installed Example(s):
Brookhaven National Laboratories
Idaho National Laboratories - HPIL
Los Alamos National Laboratories
Idaho National Laboratories - DOELAP

Hopewell Designs, Inc.
5940 Gateway Drive, Alpharetta, GA 30004
770-667-5770 / FAX 770-667-7539
sales@hdirad.com